Panier (0)
Standard

IEEE C37.13-2015

Révisé

Note: Actuellement en cours d'élaboration: IEEE C37.13-2024

Aperçu

Amendements et versions existants ou nouveaux doivent être achetés séparément.

Langue
Format

Résumé

Revision Standard - Superseded. The following enclosed low-voltage ac power circuit breakers are covered in this standard: a) stationary or drawout type of two-, three-, or four-pole construction, with one or more rated maximum voltages of 1058 V, 730 V, 635 V (600 V for units incorporating fuses), 508 V, or 254 V for application on systems having nominal voltages of 1000 V, 690 V, 600 V, 480 V, or 240 V; b) unfused or fused circuit breakers; c) manually or power operated; and d) with or without electromechanical or electronic trip devices. Service conditions, ratings, functional components, temperature limitations and classifications of insulating materials, insulation (dielectric) withstand voltage requirements, test procedures, application, and the preferred ratings are discussed in this standard.

Spécifications des produits

  • Standard de IEEE
  • Publié:
  • Type de document: IS
  • Pages
  • Editeur: IEEE
  • Distributeur: IEEE
  • ICS: 29.130.20
  • Comité national: IEEE Power and Energy Society / Switchgear

Relations produit

  • Référence: IEC 60073, Basic and safety principles for man-machine interface, marking and identification--Coding principles for indicators and actuators.
  • Référence: ANSI C37.50-2012, American National Standard Switchgear Low-Voltage AC Power Circuit Breakers Used in Enclosures--Test Procedures.
  • Référence: ASTM D 229, Standard Test Methods for Rigid Sheet and Plate Materials Used for Electrical Insulation.
  • Référence: IEC 60947-2, Low-voltage switchgear and controlgear--Part 2: Circuit-breakers.
  • Référence: UL 94(TM), Standard for Tests for Flammability of Plastic Materials for Parts in Devices and Appliances.
  • Référence: UL 746A(TM), Standard for Polymeric Materials -- Short Term Property Evaluations
  • Référence: UL 248-1(TM), Low-Voltage Fuses--Part 1: General Requirements.