Standard

SAE J1304_200602

Feb 2006 Withdrawn

Note: Latest version: SAE J1304_201110

Existing or new amendments and versions must be purchased separately.

Language English

Services Online + Pdf CHF 37.00 Online CHF 32.00

There are no extended editions available for this standard

There are no available corrigendum or amendments for this standard. Any future corrigendum and amendments will be added automatically for subscribers.

Abstract

For cutting edges used on buckets for loaders defined in SAE J1057a. The dimensions are applicable to rolled and machined sections only. Cutting edge cross section thickness is limited to a maximum of 35 mm. Bolt-on tooth adapters are rarely used on loader buckets with cutting edge thicknesses in excess of 35 mm. This recommended practice applies only to straight cutting edges defined as those whose leading edge and rear edge are parallel and thus are of constant cross section. Overall cross sections to which bolt holes were added as indicated by this recommended practice were selected from those indicated per "Cutting Edge—Cross Sections Loader Straight," SAE J1303 FEB85. Selection was based on minimum section width requirements to accommodate bolt-on tooth adapters.

Products specifications

Standard from SAE International
Published: February 5 2006
Withdrawn: October 25 2011
Document type: IS
Pages
ISBN:

Publisher: SAE International
Distributor: SAE International

Product Relations

Replaced by: SAE J1304_201110
Replaces: SAE J1304_198502

Create subscription

Extended editions Extended editions (0)

Version history Related Corrigenda and Amendments (0)

Version history History (3)

SAE J1304_201110

SAE J1304_200602

SAE J1304_198502

Abstract

Products specifications

Product Relations