Standard

SAE AMS2201J

May 1973 Withdrawn

Existing or new amendments and versions must be purchased separately.

Language English

Services Online + Pdf CHF 85.00 Online CHF 73.00

There are no extended editions available for this standard

There are no available corrigendum or amendments for this standard. Any future corrigendum and amendments will be added automatically for subscribers.

Abstract

This specification covers established manufacturing tolerances applicable to aluminum-base alloy rolled or drawn bar, rod, wire, and forging stock. These tolerances apply to all conditions, unless otherwise noted. The term "excl" applies only to the higher figure of the specified range. The general temper designation "-TX51" is used for brevity and denotes the full temper designations -T351, -T451, -T651, -T851, and -T7351, the "X" representing one or more digits preceding the "51". Dimensions in U.S. conventional units are primary; dimensions in SI units are shown as the equivalent of the inch/foot/degree dimensions and are not to be construed as standard for product produced to SI dimensions.

Products specifications

Standard from SAE International
Published: May 15 1973
Withdrawn: October 1 1982
Document type: IS
Pages
ISBN:

Publisher: SAE International
Distributor: SAE International

Product Relations

Replaced by: SAE AMS2201K
Replaces: SAE AMS2201H

Create subscription

Extended editions Extended editions (0)

Version history Related Corrigenda and Amendments (0)

Version history History (2)

SAE AMS2201J

SAE AMS2201H

Abstract

Products specifications

Product Relations