Search scope:
Shopping cart (0)
Information Well-founded knowledge for your practice: The basic training course on standards - understand, apply, decide with confidence! To the basic training
Standard

IEEE 1210-2004

Withdrawn

Note: Latest version: IEEE 1210-1996

Preview

Existing or new amendments and versions must be purchased separately.

Language
Services

Abstract

Revision Standard - Inactive-Reserved. Criteria and test methods for determining the compatibility of cable-pulling lubricants (compounds) with cable jacket or other exterior cable covering are described in this standard. Cable pulling lubricants are used to lower the friction on cable as it is pulled into conduit, duct, or directionally bored holes. Compatibility is important because lubricants should not negatively interact with the cables they lubricate. Compatibility of lubricants with a variety of common cable coverings is considered. (An interpretation is available at http://standards.ieee.org/findstds/interps/1210-2004.html)

Products specifications

  • Standard from IEEE
  • Published:
  • Withdrawn:
  • Document type: IS
  • Pages
  • Publisher: IEEE
  • Distributor: IEEE
  • ICS: 29.060.20
  • National Committee: IEEE Power and Energy Society / Insulated Conductors

Product Relations

  • Referred by: IEEE 1185-2019
  • Referred by: IEEE 690-2018
  • Revises: IEEE 1210-1996
  • Refers: ANSI/UL 44-1999, Standard for Thermoset-Insulated Wires and Cables.1
  • Refers: ANSI/UL 83-2003, Standard For Thermoplastic-Insulated Wires and Cables.
  • Refers: ASTM D1693-2001, Standard Test Method for Environmental Stress-Cracking of Ethylene Plastics.
  • Refers: ICEA T-25-425-1981, Guide for Establishing Stability of Volume Resistivity for Conducting Polymeric Compounds of Power Cables.
  • Refers: ASTM D412-98a(2002)e1, Standard Test Methods for Vulcanized Rubber and Thermoplastic Rubbers and Thermoplastic Elastomers—Tension.2
  • Refers: ANSI/UL 1581-2001, Reference Standard for Electrical Wires, Cables, and Flexible Cords.
  • Refers: ASTM D4703-2003, Standard Practice for Compression Molding Themoplastic Materials into Test Specimens, Plaques, or Sheets.