Chercher dans:
Panier (0)
Standard

IEEE C57.12.32-2019

Actuel
Aperçu

Amendements et versions existants ou nouveaux doivent être achetés séparément.

Langue
Format

Résumé

Revision Standard - Active. Design and production tests and requirements for the integrity of submersible electrical equipment intended for installation in submerged or partially submerged environments are covered in this standard. These enclosures contain energized electrical apparatus, typically not accessible to the general public including, but not limited to, the following types of equipment: submersible distribution transformers; submersible network transformers; submersible network protectors; submersible switchgear; submersible capacitors or inductors; submersible junction enclosures; submersible metering equipment; and submersible control boxes.

Spécifications des produits

  • Standard de IEEE
  • Publié:
  • Type de document: IS
  • Pages
  • Editeur: IEEE
  • Distributeur: IEEE
  • ICS: 25.220.01
  • ICS: 29.020
  • Comité national: IEEE Power and Energy Society / Transformers

Relations produit

  • Référencé par: IEEE C57.12.40-2024
  • Référencé par: IEEE C57.12.24-2023
  • Référencé par: IEEE C57.12.24-2023
  • Référencé par: IEEE C57.12.23-2018
  • Révise: IEEE C57.12.32-2002
  • Référence: ASTM D523, Standard Test Method for Specular Gloss.
  • Référence: ASTM D660, Standard Test Method for Evaluating Degree of Checking of Exterior Paints.
  • Référence: ASTM D3363, Test Method for Film Hardness by Pencil Test.
  • Référence: ASTM D4060, Standard Test Method for Abrasion Resistance of Organic Coatings by the Taber Abraser.
  • Référence: NACE SP0188, Discontinuity (Holiday) Testing of New Protective Coatings on Conductive Substrates.
  • Référence: ASTM D3170, Test Method for Chip Resistance of Coatings.
  • Référence: ASTM D610, Standard Practice for Evaluating Degree of Rusting on Painted Steel Surfaces.
  • Référence: ASTM D714, Standard Test Method for Evaluating Degree of Blistering of Paints.
  • Référence: ASTM B117, Standard Practice for Operating Salt Spray (Fog) Apparatus
  • Référence: ASTM D1654-05, Standard Test Method for Evaluation of Painted or Coated Specimens Subjected to Corrosive Environments.
  • Référence: SAE J400, Test for Chip Resistance of Surface Coatings.
  • Référence: ASTM D2794, Standard Test Method for Resistance or Organic Coatings to the Effects of Rapid Deformation (Impact).
  • Référence: ASTM D3359, Standard Methods for Measuring Adhesion by Tape Test.
  • Référence: ASTM D661, Standard Test Method for Evaluating Degree of Cracking of Exterior Paints.
  • Référence: ASTM D4587, Standard Practice for Fluorescent UV-Condensation Exposures of Paint and Related Coatings.