Standard

IEEE 1863-2024

Actuel

Note: Version actuelle: IEEE 1863-2024

Aperçu L'aperçu n'est pas disponible

Amendements et versions existants ou nouveaux doivent être achetés séparément.

Langue
Format

Résumé

Revision Standard - Active. Covered in this guide are basic principles, methods, and experience for (design of 110 kV to 1000 kV) alternating current (ac) overhead transmission lines. This guide may also be used as a reference for the design of lower-voltage overhead transmission lines. Included in this guide are an introduction, definitions, meteorological design and criteria, electrical design, structural design criteria, design of foundations, experiment results, and design experience. This guide is a listing of the information and procedures that can be referenced during the design of ac transmission lines. Guidance is provided for transmission line designers in the data collection design stage.

Spécifications des produits

  • Standard de IEEE
  • Publié:
  • Type de document: IS
  • Pages
  • Editeur: IEEE
  • Distributeur: IEEE
  • ICS: 29.240.20
  • Comité national: IEEE SA Board of Governors / Entity Collaborative Activities Governance Board

Relations produit

  • Référence: IEEE 516-2021
  • Révise: IEEE 1863-2019
  • Révise: IEEE 1863-2019
  • Référence: IEEE 80-2013
  • Référence: IEEE 80-2013
  • Référence: IEEE 1862-2014
  • Référence: IEEE C95.6-2002
  • Référence: IEEE 691-2001
  • Référence: IEEE 1243-1997
  • Référence: IEC 60071-2:2023, Insulation Co-ordination-Part 2: Application Guidelines.
  • Référence: IEC TS 63042-202:2021, UHV AC Transmission Systems-Part 202: UHV AC Transmission Line Design.
  • Référence: ASCE MOP 141, Wood Pole Structures for Electrical Transmission Lines: Recommended Practice for Design and Use.
  • Référence: ASCE/SEI 10-15, Design of Latticed Steel Transmission Structures.
  • Référence: ASCE MOP 104, Recommended Practice for Fiber-Reinforced Polymer Products for Overhead Utility Line Structures (Second Edition).
  • Référence: IEC TS 60815-1:2008, Selection and Dimensioning of High-Voltage Insulators Intended for Use in Polluted Conditions-Part 1:Definitions, Information and General Principles.
  • Référence: ASCE/SEI 48-19, Design of Steel Transmission Pole Structures.
  • Référence: IEC 61284, Overhead lines-Requirements and tests for fittings.
  • Référence: ASCE MOP 74-2020, Guidelines for Electrical Transmission Line Structural Loading (Fourth Edition).
  • Référence: IEC TS 60815-3:2008, Selection and Dimensioning of High-Voltage Insulators Intended for Use in Polluted Conditions-Part 3: Polymer Insulators for A.C. Systems.
  • Référence: ASCE MOP 123, Prestressed Concrete Transmission Pole Structures: Recommended Practice for Design and Installation.