Standard

SAE AS5798

Nov 2013 Withdrawn

Existing or new amendments and versions must be purchased separately.

Language English

Services Online + Pdf CHF 93.00 Online CHF 80.00

There are no extended editions available for this standard

There are no available corrigendum or amendments for this standard. Any future corrigendum and amendments will be added automatically for subscribers.

Abstract

This SAE Aerospace Standard (AS) is applicable to military and commercial aircraft. It specifies the dimensions, tolerances and size codes (dash numbers) for use in glands per MIL-G-5514 where squeeze at low temperature is often insufficient to provide a leak-tight seal. The dimensions and tolerances specified in this standard are suitable for any elastomeric material. This standard should not be used as a part standard, therefore no part numbers like AS5798-001X shall be created. Each dash number, which should be appended to an appropriate drawing or standard number, identifies one size O-ring only. An AS5798 sized O-ring is intended to replace an AS568 sized O-ring of the same dash number. An X suffix is part of the dash number to signify oversize. Temperature limitations of 275 °F (135 °C) and coefficient of thermal expansion of 9.0 × 10 2x unit length per °F (1.6 × 10 2x unit length per °C) were used for swell calculations. Applications that exceed these values should be evaluated for excessive gland fill.

Products specifications

Standard from SAE International
Published: November 22 2013
Withdrawn: December 2 2019
Document type: IS
Pages
ISBN:

Publisher: SAE International
Distributor: SAE International

Product Relations

Replaced by: SAE AS5798A
Refers: SAE AS4724
Refers: SAE AS4716
Refers: SAE AS568

Create subscription

Extended editions Extended editions (0)

Version history Related Corrigenda and Amendments (0)

Abstract

Products specifications

Product Relations