Search scope:
Shopping cart (0)
Standard

IEEE 2960-2023

Current
Preview

Existing or new amendments and versions must be purchased separately.

Language
Services

Abstract

New IEEE Standard - Active. Stationary Meter Test Units (MTUs) permanently installed in laboratories, used for testing and calibration of direct current electrical energy meters, in particular for their type test, acceptance test, and verification test, are applied to in this guide. The requirements for automatic MTUs and applies to newly manufactured MTUs to test electrical energy meters on direct current systems with a voltage up to 1 500 V is covered. Finally, it should be noted that the entire guide does not contain normative requirements

Products specifications

  • Standard from IEEE
  • Published:
  • Document type: IS
  • Pages
  • Publisher: IEEE
  • Distributor: IEEE
  • ICS: 17.220.20
  • National Committee: IEEE Power and Energy Society / Power System Instrumentation and Measurements

Product Relations

  • Refers: IEEE 1653.2-2020
  • Refers: IEEE 1881-2016
  • Refers: IEC 62053-41 Electricity metering equipment -- Particular requirements -- Part 41 -- Static meters for DC energy (class 0,5 and 1).
  • Refers: IEC 62052-11 Electricity metering equipment -- General requirements, tests and test conditions -- Part 11: Metering equipment.
  • Refers: IEC 61010-031, Safety requirements for electrical equipment for measurement, control and laboratory use -- Part 031: Safety requirements for hand-held probe assemblies for electrical measurement and test.
  • Refers: IEC 61010-1, Safety requirements for electrical equipment for measurement, control, and laboratory use -- Part 1: General requirements.
  • Refers: IEC 61326-1, Electrical equipment for measurement, control and laboratory use -- EMC requirements -- Part 1: General requirements.
  • Refers: IEC Guide 98-3 (GUM: 1995/ JCGM 100:2008) Uncertainty of measurement -- Part 3: Guide to the expression of uncertainty in measurement.
  • Refers: ANSI Z535.4, American National Standard for Product Safety Signs and Labels.
  • Refers: IEC 60664-1, Insulation coordination for equipment within low-voltage supply systems -- Part 1: Principles, requirements and tests.