Chercher dans:
Panier (0)
Standard

IEEE 2960-2023

Actuel
Aperçu

Amendements et versions existants ou nouveaux doivent être achetés séparément.

Langue
Format

Résumé

New IEEE Standard - Active. Stationary Meter Test Units (MTUs) permanently installed in laboratories, used for testing and calibration of direct current electrical energy meters, in particular for their type test, acceptance test, and verification test, are applied to in this guide. The requirements for automatic MTUs and applies to newly manufactured MTUs to test electrical energy meters on direct current systems with a voltage up to 1 500 V is covered. Finally, it should be noted that the entire guide does not contain normative requirements

Spécifications des produits

  • Standard de IEEE
  • Publié:
  • Type de document: IS
  • Pages
  • Editeur: IEEE
  • Distributeur: IEEE
  • ICS: 17.220.20
  • Comité national: IEEE Power and Energy Society / Power System Instrumentation and Measurements

Relations produit

  • Référence: IEEE 1653.2-2020
  • Référence: IEEE 1881-2016
  • Référence: IEC 62053-41 Electricity metering equipment -- Particular requirements -- Part 41 -- Static meters for DC energy (class 0,5 and 1).
  • Référence: IEC 62052-11 Electricity metering equipment -- General requirements, tests and test conditions -- Part 11: Metering equipment.
  • Référence: IEC 61010-031, Safety requirements for electrical equipment for measurement, control and laboratory use -- Part 031: Safety requirements for hand-held probe assemblies for electrical measurement and test.
  • Référence: IEC 61010-1, Safety requirements for electrical equipment for measurement, control, and laboratory use -- Part 1: General requirements.
  • Référence: IEC 61326-1, Electrical equipment for measurement, control and laboratory use -- EMC requirements -- Part 1: General requirements.
  • Référence: IEC Guide 98-3 (GUM: 1995/ JCGM 100:2008) Uncertainty of measurement -- Part 3: Guide to the expression of uncertainty in measurement.
  • Référence: ANSI Z535.4, American National Standard for Product Safety Signs and Labels.
  • Référence: IEC 60664-1, Insulation coordination for equipment within low-voltage supply systems -- Part 1: Principles, requirements and tests.